This article applies to AE-32 Audio Engine and JetStream

This article applies to vMix + and vScreen

This article applies to Pilot, ROC, Mosaic, and Helix consoles


If you have an AE-32 or JetStream set up for an Artisan console of a JetStream set up for a Helix Television and Helix Television Studio console, see the article for Television consoles.


When designing custom vMix+ and vScreen designs, you need to know the addresses of the meters to display them.

Don't forget to check the box to set the meter for Input or Output


Output Meters

You can only meter the outputs of the mix buses listed below. You cannot assign the address of an engine output and get a meter. This is because the DSP creates the meters, and audio card outputs don't go through the DSP.


AE-32 LS-DSP (LoneSHARC) cards have the following addresses:

Port 1 Program Out
Device 04
Port 1 Monitor Out
Device 05
Port 2 Program Out
Device 06
Port 2 Monitor Out
Device 07
Port 3 Program Out
Device 08
Port 3 Monitor Out
Device 09    

All device numbers are in hex


AE-32 SA-DSP (SHARC Attack) and all JetStream systems use the above output addresses plus the following:

Port 1 Cue Out    
Device 2D
Port 1 Aux 1 Out    
Device 2E
Port 1 Aux 2 Out
Device 2F
Port 1 Aux 3 Out
Device 30 (This is shared with Router 1 In; Aux out supersedes input data)
Port 1 Aux 4 Out    
Device 31 (This is shared with Router 2 In; Aux out supersedes input data)
Port 1 Aux 5 Out    
Device 32 (This is shared with Router 3 In; Aux out supersedes input data)
Port 2 Aux 1 Out
Device 56 (This is shared with Port 2 Mixer A 2 In; Aux out supersedes input data)
Port 2 Aux 2 Out
Device 57 (This is shared with Port 2 MixerA 3 In; Aux out supersedes input data)
Port 2 Aux 3 Out
Device 58 (This is shared with Port 2 Router 1 In; Aux out supersedes input data)
Port 2 Aux 4 Out
Device 58 (This is shared with Port 2 Router 2 In; Aux out supersedes input daa)
Port 2 Aux 5 Out
Device 5A (This is shared with Port 2 Router 3 In; Aux out supersedes input data)

All device numbers are in hex.


Input Meters


There are no input meters on the LS-DSP (Lone SHARC) cards on the AE-32.

Input Meters for the SA-DSP (SHARC Attack) on the AE-32 and all JetStream systems are as follows:

DSP Device Name
DSP Address (hex) Port 1
DSP Address (hex) Port 2
DSP Address (hex) Port 3
Fader inputs
0b - 22
33-4A
5b-60
Mixer A In 1    
2D
55

Mixer A In 2
2E
56*

Mixer A In 3
2F
57*

Router 1 In (Profanity Delay)
30*
58*

Router 2 In
31*
59*

Router 3 In
32*
5A*

* shared with Aux Out metering. The input meter supersedes the output meter.


Additional system addresses are found on the attached spreadsheet.